Machining Operations Engineer/ Process Engineer in Winsted, CT at Arconic

Date Posted: 4/22/2018

Job Snapshot

  • Employee Type:
  • Location:
    Winsted, CT
  • Job Type:
  • Experience:
    At least 4 year(s)
  • Date Posted:

Job Description

The Machining Operations Engineer/ Process Engineer is responsible for development and implementation of product into the manufacturing operation to meet production requirements and quoted cost. The major emphasis in the position is the technical support of tooling, work instructions, process/method definition and floor support for this growing facility.

Essential Functions
  • Troubleshoot operations including but not limited to; fixturing/clamping issues, program and/or parameter issues and expendable tooling issues until problem is resolved.
  • Poke-yoke fixturing using the fixture maintenance program for any other mistake proofing method to increase yields on high scrap operations/programs to support scrap reduction initiatives and deduce human error.
  • Time study jobs to balance and define operator standard work.
  • Generate standard work charts and process capacity table comparing actual performance to quoted estimates in current cost models (WPQ folder).
  • Utilize SPC charts and other process capability methods to increase first time yields within quoted standards.
  • Perform process planning and development of newly awarded product to include tooling procurement, standard routings, bill of materials, etc.
  • Follow policies and procedures as outlined in Employee Handbook.
  • Perform all other job duties as assigned.

Basic Qualifications

  • Bachelor's Degree from an accredited institution.
  • Minimum of 2 years of engineering or operations experience within in a manufacturing environment.
  • This position is subject to the International Traffic in Arms Regulations (ITAR) which requires U.S. person status. ITAR defines U.S. person as a U.S. Citizen, U.S. Permanent (i.e., Green Card Holder), Political Asylee or Refugee

Preferred Qualifications

  • Bachelor's Degree in engineering from an accredited institution
  • Experience in a machining, aerospace or power propulsion environment
  • Experience with AutoCAD
  • Training/Experience with Lean Manufacturing and Six Sigma Tools
  • Working knowledge of statistical analysis including Minitab